Nord G2 editor not working while using a JazzMutant Lemur?

paugui · Last edited by paugui on Fri Feb 01, 2013 4:42 am; edited 1 time in total

I had never had a single problem with my Nord Modular G2 Engine, but today I wanted to use it to test my new JazzMutant Lemur.

Unfortunately, when I connected it to USB to the computer, I can't get the USB light to turn on and there is no response from the Editor either.
I tried to turn it on and off a couple of times, and no change...
I also tested the cables and the USB ports in the computer with other gear, and they work just fine.

I know I used it the last time a month or so ago and couldn't find any signs of the USB failing.

I think I remember seeing posts about that, but couldn't find them here...
Can it be just some soldering problem, or something more serious, since there were no signs of a problem before?

If it's more serious, what can be done to solve it?

Thanks in advance and
All the best

Paulo

paugui · Posted: Fri Feb 01, 2013 4:41 am Post subject:

Upon further tests, it seems it's working well...

I think the problem might be some incompatibility with my Lemur?

I noticed that my G2X wasn't working either and that would have to be too much bad luck...
I restarted the computer and it seems it's working well now...

Anybody else here tried to use the G2 together with a Lemur and found the same problems?

Blue Hell · Posted: Fri Feb 01, 2013 7:38 am Post subject:

It may not be related to the Lemur ... occasionally the G2 USB driver will just crash ... I just reboot the computer when that happens.

paugui · Posted: Fri Feb 01, 2013 7:56 am Post subject:

Maybe it's that then...

I thought it could be the Lemur cause with the Wifi on, it sometimes has troubles connecting...

And since it never happened to me before, I thought it could be related...

But fortunately everything is working well now Smile