555 VCO not sounding

[MapacheRaper]

Hi guys, I have built this sexy thing but Im getting no sound...

Is there any guide or table of pin/voltages for troubleshooting this?

---

IMG_20180918_014904.jpg
Description:
Filesize:	178.67 KB
Viewed:	496 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---

---

IMG_20180918_015038.jpg
Description:
Filesize:	262.08 KB
Viewed:	503 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---

---

IMG_20180918_015052.jpg
Description:
Filesize:	315.48 KB
Viewed:	543 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---

---

IMG_20180918_015128.jpg
Description:
Filesize:	209.98 KB
Viewed:	540 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---

[comrade_zero]

You have omitted the (tempco ) resistor that fits over the exponential transistors. You can use a normal resistor here if you do not have a tempco, (but you will drift out of tune more quickly) but the vco will not sound without a resistor there. It's been a while since I built my board, but it is either 1k or 2k... You may want to look over your soldering in general, it looks a bit rough in some spots.
Good luck, and I hope this helps.
c_z

[MapacheRaper]

Hawk eyes, no doubth.

Yeah, I forgot to put the tempco. I found it and solder it some days after posting this thread, but I forgot to say it. The OSC is working nicely since then.

Thank you so much for taking the time to sherlock holms it