electro-music.com   Dedicated to experimental electro-acoustic
and electronic music
 
    Front Page  |  Radio
 |  Media  |  Forum  |  Wiki  |  Links
Forum with support of Syndicator RSS
 FAQFAQ   CalendarCalendar   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   LinksLinks
 RegisterRegister   ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in  Chat RoomChat Room 
 Forum index » Online Music
AlanP's Awfulness
Post new topic   Reply to topic
Page 3 of 3 [64 Posts]
View unread posts
View new posts in the last week
Mark the topic unread :: View previous topic :: View next topic
Goto page: Previous 1, 2, 3
Author Message
AlanP



Joined: Mar 11, 2014
Posts: 746
Location: New Zealand
Audio files: 41

PostPosted: Tue Aug 14, 2018 12:07 am    Post subject: Reply with quote  Mark this post and the followings unread

The Gate Out of Stage 1 went to trigger the Elements input on the switch, Gate Out of Stage 5 went to trigger the Braids input on the switch. I could have ran the clock into a divide by 4, but then I might have sync issues.

Elements wound up going into the CGS60 Stompbox Adaptor, purely for additional gain to ramp it up to Braids' level. The minor shimmer in it's chuffs was from a LFO into the Tone CV for the Blow exciter. (The moving tone in the exciter has an effect on the resonator section in turn.)

I tried running the final mix into the Serge Resonant EQ to get rid of that minor blip when going from Elements to Braids, but no luck. I also tried delaying the Gate Out of Stage 5 a little bit (run that into the Gate In of the Rampage, run the Falling output of Rampage into the switch trigger, play with the Rise time to get a gate delay), but that also didn't do much. I'll have to think about it.
Back to top
View user's profile Send private message
Grumble



Joined: Nov 23, 2015
Posts: 1294
Location: Netherlands
Audio files: 30

PostPosted: Tue Aug 14, 2018 10:48 pm    Post subject: Reply with quote  Mark this post and the followings unread

AlanP wrote:
Chuff sounds was Elements, chord sounds was Braids in three-saw mode with the other two saws tuned lower and lower again, then run through a reverb.

Great sounds! Very Happy

_________________
my synth
Back to top
View user's profile Send private message Visit poster's website
AlanP



Joined: Mar 11, 2014
Posts: 746
Location: New Zealand
Audio files: 41

PostPosted: Fri Nov 09, 2018 9:25 pm    Post subject: Reply with quote  Mark this post and the followings unread

Dad was around today, and I had some fun putting a patch together.

Changes roughly just after 4min into it.


2018-11-10.JPG
 Description:
 Filesize:  306.33 KB
 Viewed:  615 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

2018-11-10.JPG



2018-11-10 dadfun.mp3
 Description:

Download
 Filename:  2018-11-10 dadfun.mp3
 Filesize:  7.88 MB
 Downloaded:  1573 Time(s)

Back to top
View user's profile Send private message
Grumble



Joined: Nov 23, 2015
Posts: 1294
Location: Netherlands
Audio files: 30

PostPosted: Fri Nov 09, 2018 11:52 pm    Post subject: Reply with quote  Mark this post and the followings unread

I can’t play it right now, one of the dogs starts barking when I play this...
Shocked

_________________
my synth
Back to top
View user's profile Send private message Visit poster's website
blue hell
Site Admin


Joined: Apr 03, 2004
Posts: 24079
Location: The Netherlands, Enschede
Audio files: 278
G2 patch files: 320

PostPosted: Sun Nov 25, 2018 1:33 pm    Post subject: Reply with quote  Mark this post and the followings unread

Some nice Awfulness there :-)

(and can't blame the dogs for recognizing the sounds)

_________________
Jan
also .. could someone please turn down the thermostat a bit.
Posted Image, might have been reduced in size. Click Image to view fullscreen.
Back to top
View user's profile Send private message Visit poster's website
AlanP



Joined: Mar 11, 2014
Posts: 746
Location: New Zealand
Audio files: 41

PostPosted: Tue May 14, 2019 11:30 pm    Post subject: Reply with quote  Mark this post and the followings unread

Had another play with the Appendage Touch Controller today. I'm not sure... but when I take my finger off the ribbon, sometimes the CV will drop very low, riiiight on the very end before the Gate goes low. In this patch, it was controlling Mutable Elements. (Pho, you really need to build this one!)

Erm, the background sequence is mainly to give me a beat, not for a melody to bounce riffs off.

I messed with the Contour knob on Elements a couple times.


2019-05-14 testtouch.mp3
 Description:

Download
 Filename:  2019-05-14 testtouch.mp3
 Filesize:  5.92 MB
 Downloaded:  1237 Time(s)

Back to top
View user's profile Send private message
AlanP



Joined: Mar 11, 2014
Posts: 746
Location: New Zealand
Audio files: 41

PostPosted: Sat Apr 25, 2020 11:57 pm    Post subject: Reply with quote  Mark this post and the followings unread

Short test of the snare, hi-hat (both open and closed), and the Bastl Tea Kick because why not. All sequenced by the mighty Per|former sequencer.


2020-04-26 drum test.mp3
 Description:

Download
 Filename:  2020-04-26 drum test.mp3
 Filesize:  904.97 KB
 Downloaded:  851 Time(s)

Back to top
View user's profile Send private message
PHOBoS



Joined: Jan 14, 2010
Posts: 5591
Location: Moon Base
Audio files: 705

PostPosted: Tue Apr 28, 2020 5:49 am    Post subject: Reply with quote  Mark this post and the followings unread

sounds great alan
_________________
"My perf, it's full of holes!"
http://phobos.000space.com/
SoundCloud BandCamp MixCloud Stickney Synthyards Captain Collider Twitch YouTube
Back to top
View user's profile Send private message Visit poster's website AIM Address Yahoo Messenger MSN Messenger
AlanP



Joined: Mar 11, 2014
Posts: 746
Location: New Zealand
Audio files: 41

PostPosted: Thu Jun 18, 2020 1:38 pm    Post subject: Reply with quote  Mark this post and the followings unread

Two NLC Triple Sloths modules were the core for this.

Voice A - 258 dual osc, one side's audio going into the FM for the other side (that I took the audio output from), going into the 291 Bandpass, then off to the output module.

Voice B - Braids, into Yusynth ARP4072, then output module.

Voice C - Haible Living VCOs, into audio mixer, into Yusynth Minimoog VCF, into output module.

All with liberal amounts of CV from the two triple sloths module.


2020-06-19 two triple sloths.mp3
 Description:

Download
 Filename:  2020-06-19 two triple sloths.mp3
 Filesize:  21.98 MB
 Downloaded:  882 Time(s)

Back to top
View user's profile Send private message
AlanP



Joined: Mar 11, 2014
Posts: 746
Location: New Zealand
Audio files: 41

PostPosted: Fri Jun 26, 2020 4:13 pm    Post subject: Reply with quote  Mark this post and the followings unread

208 Stored Program Sound Source with a basic krell patch, going through the MTM Reverb (wet/dry controlled by the 266 FRV.)

The 208 isn't completely finished, yet, still waiting on the spring tank.


easelpatch.jpg
 Description:
 Filesize:  379.82 KB
 Viewed:  254 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

easelpatch.jpg



rec_20200627-104008_1.mp3
 Description:

Download
 Filename:  rec_20200627-104008_1.mp3
 Filesize:  17.65 MB
 Downloaded:  866 Time(s)

Back to top
View user's profile Send private message
AlanP



Joined: Mar 11, 2014
Posts: 746
Location: New Zealand
Audio files: 41

PostPosted: Wed Oct 28, 2020 12:38 am    Post subject: Reply with quote  Mark this post and the followings unread

The last parts for my DIY 4MS Spectral Multiband Resonator turned up, soldering ensued, and playing around with it. This thing is insanely fun, and all I've done so far is run white noise into it, and plug various random voltages into it's control inputs!

The Dunno module (Buchla 266) is providing white noise, and clocked random voltages (which are going through comparators to provide triggers to rotate the bands either up or down in pitch), and the Triple Sloths module is providing CV to the Spread control, the Envelope CV In (I think), and the Resonance CV In. I'm not sure how much the last two were doing anything.

Lots of fun!


2020-oct-28patch.JPG
 Description:
 Filesize:  397.4 KB
 Viewed:  224 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

2020-oct-28patch.JPG



2020-10-28 smr dunno sloth.mp3
 Description:

Download
 Filename:  2020-10-28 smr dunno sloth.mp3
 Filesize:  7.5 MB
 Downloaded:  755 Time(s)

Back to top
View user's profile Send private message
blue hell
Site Admin


Joined: Apr 03, 2004
Posts: 24079
Location: The Netherlands, Enschede
Audio files: 278
G2 patch files: 320

PostPosted: Sat Oct 31, 2020 5:39 am    Post subject: Reply with quote  Mark this post and the followings unread

AlanP wrote:
The last parts for my DIY 4MS [...] Lots of fun!


Some nice sounds from that one!

_________________
Jan
also .. could someone please turn down the thermostat a bit.
Posted Image, might have been reduced in size. Click Image to view fullscreen.
Back to top
View user's profile Send private message Visit poster's website
AlanP



Joined: Mar 11, 2014
Posts: 746
Location: New Zealand
Audio files: 41

PostPosted: Fri Nov 19, 2021 6:21 pm    Post subject: Reply with quote  Mark this post and the followings unread

Sloth providing CV to Orgone Accumulator, through the Easel, and then through the Manhattan SVVCF (HP mode). Other drone is the 258, run by the Dunno, through the 291 VCF in BP mode.


2021-11-20.mp3
 Description:

Download
 Filename:  2021-11-20.mp3
 Filesize:  4.39 MB
 Downloaded:  394 Time(s)

Back to top
View user's profile Send private message
blue hell
Site Admin


Joined: Apr 03, 2004
Posts: 24079
Location: The Netherlands, Enschede
Audio files: 278
G2 patch files: 320

PostPosted: Sat Nov 20, 2021 12:36 pm    Post subject: Reply with quote  Mark this post and the followings unread

Wild track :)
_________________
Jan
also .. could someone please turn down the thermostat a bit.
Posted Image, might have been reduced in size. Click Image to view fullscreen.
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic
Page 3 of 3 [64 Posts]
View unread posts
View new posts in the last week
Goto page: Previous 1, 2, 3
Mark the topic unread :: View previous topic :: View next topic
 Forum index » Online Music
Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Forum with support of Syndicator RSS
Powered by phpBB © 2001, 2005 phpBB Group
Copyright © 2003 through 2009 by electro-music.com - Conditions Of Use