FS: A load of CNC engraved front panels (and other bits)

[julian]

I have been going over the shelves and have a load of CNC engraved panels for sale, and some pactec pt10 cases.

Some of these are graded panels, with small defects (which are noted and photographed) and some are just surplus.

Some of the ones with marks, etc, ive put aside as im not going to post stuff out that i can see errors on, but, in reality, when
the build is complete some will be virtually impossible to spot. Some of these will give a huge saving against going to FPE etc.
for virtually the same end result : )


Ive copied and pasted the descriptions below, but theres more info, prices, photos etc here - http://www.thebeast.co.uk/cnc/sale/


Thanks, Julian

ps. im in the UK, but ship all over : )



Midibox 6285 panel set (front and rear) - cut in blue and infilled in white
x0xb0x panel set (front and rear) - cut in matt black without infill (silver writing)
5u Oakley VC-LFO - cut in matt black with white infill
5u Oakley Discontinuity - cut in matt black with white infill
5u Oakley Discontinuity - cut in matt black with no infill (silver writing)
3u x 4hp Eurorack Moog Voyager break out - cut in matt black with white infill
Frac into Euro adapter
5u Oakley Discontinuity - cut in matt black with white infill
Midibox 6285 panel set (front and rear) - cut in matt black and infilled in yellow
x0xb0x panel set (front and rear) - cut in blue without infill (silver writing)
19" x 1u Oakley Filtrex 2 panel - cut in 3mm natural silver with black infill
Pactec PT-10 cases
5u Oakley Sample / Slew - cut in matt black with no infill (silver writing)
5u Oakley Cascaded OTA Filter - cut in matt black with no infill (silver writing)
5u Oakley Noise / Filter - cut in matt black with no infill (silver writing)