Virus TI Hypersaw + Filter Routing

[Chrono]

Hallo allemaal

I've build a new patch based on the Virus TI2 Hypersaw
You can load this patch in a performance to get more layers.
That will reduce the voice amount ofcourse.
This patch is made with Expanded NMG2

PAGE A1: Detune, Transpose, Finetune, Volume
PAGE A3: Layer1 Layer2 Layer3 Layer4 Layer5 Layer6 Layer7 Layer8
PAGE C1: AMPenv Attack, Decay, Sustain, Release
PAGE C2: FILTERenv Attack, Decay, Sustain, Release
PAGE C3: MODenv Attack, Decay, Sustain, Release
PAGE D1: Cutoff, Res, Poles, Cutoff2, Res2, Poles2, Distort, Routing
PAGE D2: Dual Cutoff, DistGain
PAGE E1: 3 Band EQ On/Off , Lo, Mid, MidFrq, Hi, Peak EQ freq, Gain, Bwidth
PAGE E2: Delay amount, (L) Clock, Time, FB, FLT LP
PAGE E3: (R) Clock, Time, FB, Flt LP , , , Master Volume

Give me your opinion
i would like to know if i could reduce memory somehow.

---

Hypersaw Saw v1.pch2
Description:	Hypersaw emulated by Jasper Broeks	Download
Filename:	Hypersaw Saw v1.pch2
Filesize:	8.55 KB
Downloaded:	4724 Time(s)

---

[Lfohead]

Great work man , i like it!

[Chrono]

Thanks!

sadly there was no memory left for an LFO.
i might try patching a monophonic lfo from the fx section.

[Electromagnetic Wave]

Hi Chrono!

Have you fix the OSC phase issue into the "Virus TI Hypersaw + Filter Routing" patch ? Is it your "G2-> Virus A" update (but now for the Virus TI) you spoke some time before? I'm very concerned about this problem.

I will check this Virus TI patch tomorow.

[Chrono]

Thanks for your reply,

I've been working with Reaktor a lot, figuring out certain algorythms/tricks etc

The main thing i found to beef it up is by microtuning each voice individually.
Wich means every note you press has a slightly different tune wich cancels out annoying phase artifacts when like playing a simple saw and press 2 notes in octave. or by setting the Amp env release up.

I have not yet did this with the NMG2. Can have a try and see if it works.